AN 01-25CN-2	PARAGRAPH 1

5. Unbutton the four Dzus fasteners on the wheel's outer fairing and remove the fairing.    6. Remove the axle cap and the cotter pin and turn the large nut off the axle, freeing the wheels. Pull the wheel and wheel bearings from the axle.    7. Free the upper forward circumference of the canvas in the wheel pocket and turn the canvas out, exposing the structural detail in the wheel pocket.    8. Partially retract the landing gear so that the upper retracting links and retracting strut piston end through bolt are accessible through the wheel pocket. (See Fig. 48.)		9. Disconnect the landing gear position indicator linkage at the lower end.    10. Remove the cotter pin, nut, and through bolt connecting the retracting strut piston end to the tipper landing gear retracting links. (See Figs. 49 and 50.)    11. Return the piston completely into the retracting strut by placing the landing gear handle on the control valve in the "DOWN" position and actuating the electric hydraulic pump switch on the control, stick.

---